MULLET gets its hairdryer...TURBO

[BigRod1300]

I dought even when I do the motor work..Ill ever push it up to over 18psi boost....dont need that type of power..plus the AVON 330 tire will never hook it to the ground. UNless Shinko.....can make me a one-off 330 tire

 

[BigRod1300]

Fuel PSI guage on.
Plenum connected to up pipe
Up pipes finished
Tank back on.
GETTING SO CLOSE
Waiting on Samco blue silicone radiator hose........

 

[expat1970]

looking good rod

 

[ktw88q]

 

[crazy_mooh]

Look Good

 

[BigRod1300]

More pics.
Shortend the -8an fuel feed...all connected now.
Battery in.
Water pump installed for the heat exchanger of the intercooler.
some misc

 

[BigRod1300]

Have plans to hang out at my welders place Friday night...be making up the dump pipes
Only waiting on the Samco silicon radiator hoses........
lease: Might be riding this weekend?

 

[BigRod1300]

Samco silicone hoses on.
Fluid filled and all checked.
On the truck and heading to welders place after work to make the dump pipes.

THe EBAY GenII radiator has a small pin leak on the right side...

But other than that........:bounce::bounce::bounce::bounce::bounce:
Went down the road and back before putting it up on the truck...did NOT get a chance to bring in boost thu.

 

[megawatt]

Hurry up

 

[MAN U R SlOW]

Very nice build.. Where did you get the samco hoses and the dump pipe tubing?

 

[BigRod1300]

Very nice build.. Where did you get the samco hoses and the dump pipe tubing?

THe Samco hose kit is from OPPracing.com $235+shipping
The silicone connectors from siliconeintakes.com
I also got the dump pipe material from them too.

 

[BigRod1300]

Made up the turbo dump pipe. Its 2.5" then to a 3". In these pics it long....so I can make a slash style cut on it. Also installed the bung and sendor for the AEM A/F guage. Next it to move onto the 1.7" waste dump pipe.

 

[BigRod1300]

Ok..dont know what happend to the pics...lets try again.???

 

[BigRod1300]

Here I was playing around with blue tape to simulate a slash cut.
Also pic of how the left fairing cut worked with the up pipe.

 

[BigRod1300]

Just finished cutting the left fairing for the filter. Man..cutting this worked my nerves. Had to step way and do something else. So I moved my under hump air psi guage for the stored tank air......to the right side frame hole ( the hole you use to access the top shock bolt), Now I can check how much stored psi air I have in the tank for my air shifter.

 

[BigRod1300]

Ok...,more pics of the filter cutting.

 

[TruWrecks]

Looking good!!!

 

[turbobusa2000]

Nice work. Won't be long now. When do you plan on getting it dialed in, getting some dyno #'s.

 

[601ronron]

Take the cut for the dump pipe out just a little. The heat will attack your foot

 

[BigRod1300]

Nice work. Won't be long now. When do you plan on getting it dialed in, getting some dyno #'s.

PLan is scheduled for 2nd week of May ( 2 weeks out ). Tuner just trying to nail down the day.