goblinsix
Registered
I installed the T-Rex No-Cut frame sliders today...it was very easy. Just swap out the engine mount bolts and screw in the new brackets. The trick for me was cutting through the PPM chrome screens that I like so much without making a mess. It was no small fete. The margin for error when cutting through them was very high. I didn't do a perfect job, but it is only really visible up-close and personal. It was the best I could do with them without hacking up the screens. I broke out the Dremel and polished them down to a smooth surface.
Luckily I left enough screen to go back in and trim a nice clean circle or square around the slider shaft.
Luckily I left enough screen to go back in and trim a nice clean circle or square around the slider shaft.
Last edited: