Shop Stands For"busa"?





#1
Looking for ideas to get the front end up to change tire. I have "Pit Bull" stands. But, the BUSA is BIG.
Any suggestions? Want do this as safe as possible.
 

MC MUSTANG

Peace Keeper or Ban Hammer-it's up to you; IDMBT#9
Staff member
Administrator
Registered
#2
Pitbull stands are fine, you won't have any problems.
 
#3
Unless I attempt to use a "Cheater" pipe over the handle, I won't be able to raise the rear. The front, I have two options. The fork stand or, the "pin" style.
Not sure if I can get the "pin" style under the front fairing.
 

nosbig

Registered
#4
I can get the pin style under my front fairing. Don't think it would be as easy if the the bike was lowered though, would probably have to remove the front fender first. I am sure someone here has done it and can chime in on a lowered bike.
 

sixpack577

Top Gun
Registered
#6
I can get the pin style under my front fairing. Don't think it would be as easy if the the bike was lowered though, would probably have to remove the front fender first. I am sure someone here has done it and can chime in on a lowered bike.
If the arm will still fit between the fender and fairing, driving the front tire up on a 2x4 makes it easier to lift a lowered bike.
I always throw an old towel over the front fender of any bike too.
 

nosbig

Registered
#8
If the arm will still fit between the fender and fairing, driving the front tire up on a 2x4 makes it easier to lift a lowered bike.
I always throw an old towel over the front fender of any bike too.
Good tip with the towel. My bike isn't lowered and I don't have a problem. If I am removing the front tire I do use the 2×4 trick. I read about it on here before I ever tried taking the tire off the bike. I don't even know how hard it would be without it, never tried.
 

sixpack577

Top Gun
Registered
#9
Good tip with the towel. My bike isn't lowered and I don't have a problem. If I am removing the front tire I do use the 2×4 trick. I read about it on here before I ever tried taking the tire off the bike. I don't even know how hard it would be without it, never tried.
Depends on the stand, but most front stands don't lift the Busa high enough to get the front wheel out with the gen2 fender still on.
The downward front slope on the fender keeps the wheel from rolling out.
I learned that the hard way...like most things.
Including the towel. It only took the pin arm dropping on the fender once, and a nice nick in the paint.
 

sixpack577

Top Gun
Registered
#10
Depends on the stand, but most front stands don't lift the Busa high enough to get the front wheel out with the gen2 fender still on.
The downward front slope on the fender keeps the wheel from rolling out.
I learned that the hard way...like most things.
Including the towel. It only took the pin arm dropping on the fender once, and a nice nick in the paint.
The front wheel will roll out with the fender on with the Busa on the Bursig stand though!
 

Similar threads





Most likes - Past 7 days

Latest Bikes

Forum statistics

Threads
171,437
Messages
3,060,601
Members
47,123
Latest member
Blacksmith
Top