OneTrickBusa
Registered
This is my first post. I have enjoyed reading articles within this forum & I have been able to acquire most of the answers to my questions by reading all the comments. That said, Hello to All & Thanks for an Ultra Cool Forum!
???My scenario is that I have installed wheel-bearings in my 2007 Hayabusa stock chrome front wheel & over tightened the installation tool. I do not have any clearance between the spacer & the bearings (the bearings & spacer turn as one). Brilliant, if I must say so myself.
I have thought of attempting to drive one of the bearings outward to obtain some clearance, but this approach may compromise the bearing. I may have to resort to driving out one bearing & reinstalling a new one unless anyone has an alternative. Any suggestions are greatly appreciated. Thanx
???My scenario is that I have installed wheel-bearings in my 2007 Hayabusa stock chrome front wheel & over tightened the installation tool. I do not have any clearance between the spacer & the bearings (the bearings & spacer turn as one). Brilliant, if I must say so myself.
I have thought of attempting to drive one of the bearings outward to obtain some clearance, but this approach may compromise the bearing. I may have to resort to driving out one bearing & reinstalling a new one unless anyone has an alternative. Any suggestions are greatly appreciated. Thanx