Holy...those bearings. I want them.
They aren't the standard ZX12 sprocket?Finding my first hurdle with the Apex 6 wheels locating a 530 sized light steel sprocket in this pattern .
76mm Hub Diameter x 100mm Bolt Circle x 5 Bolt (10.5mm holes)
Available in 520 / 525 but not 30 . Why well the Driven rear is already wearing @ 4,xxx miles , the coating is wearing in between the teeth .
Holy...those bearings. I want them.
Thanks for sharing....I will check my sprocket when I take her apart soon.
No fellas, remember, ceramic bearings are a waste of money. It's all marketing hype. An engineer said so......Your killing me smalls!! Now I need to sell a lung to afford some wheels with ceramic bearings.
Why well the Driven rear is already wearing @ 4,xxx miles , the coating is wearing in between the teeth .
Same here. I was going a bit tighter on the busa than I do the 14 but I think that was because the busa 's cush drive was worn out. I replaced the cush drive rubbers and a looser chain felt normal.my chain has a nice soft curve rear to front sprocket , so when I sit on the bike , the chain is only then at the correct tension .
No sir . 5 bolt now pattern listed aboveThey aren't the standard ZX12 sprocket?
Great … so those Kawi sprockets I have from 42-48 won't work on my new wheels. Another few hundred bucks into the wind. I read their website and it is irritating that they make them unique. If they want a 5-bolt pattern why not just pick one of the standard patterns already out there instead of making their own?No sir . 5 bolt now pattern listed above