Well I have been putting the busa together getting everything going ect. Well after I finally got the bike started and running right I found that the magneto cover was leaking (did not seal right) and oil was seeping from the oil pan drain bolt. So I drain the oil and change the gasket on the mag cover and then go to clean the oil pan drain bolt area. So when I put my finger in the hole (bolt hole, get your mind out of the gutter!) the threads (3/4 of them fall out off the pan!) So I just got done pulling the oil pan off, I am going to have it welded and then retapped, I should have it back Wednesday and then have the fairings back sometime around then, so I should be up by this weekend maybe next Monday. Just venting. Anyone else ever have this happen? I have been using a torque wrench torqing everything to spec (since I have been reassembling the bike) but before this I was just "snugging" it, so I probably over "snugged"it. Word of advice torque it to specs so you don't have to go through this (16.5 ft lbs).
<!--EDIT|Rich
Reason for Edit: None given...|1082436031 -->
<!--EDIT|Rich
Reason for Edit: None given...|1082436031 -->