SSGT_B
Registered
So I started on this project because my bike "jumps" only when put into gear from neutral. All other operations feel fine. It also was engaging just off handlebar. I flushed the fluid and that cave an additional 1/4 in the lever. Still jumps however. After talking to a few of you guys on my other posts, I conclude that my probable cause is either worn fibers or a warped steel. Found a deal on Ebay for a complete kit with gaskets, OEM, for 113 shipped. Well frack it, went on and ordered it. Got a deal working with Rob @Boosted Cycle Perf for a welded clutch hub so I went on and pulled the clutch apart. On removal I noticed that all but the most inner steel plate is blued badly and a thick black film on the inner and outer hub assy. If this was a cars flywheel I would replace or machine so it seems as though this was good timing. I will upload more pics as parts get in ( hopefully tomorrow ) and update this post.
Last edited: