I just cut it, I was in the same place as you, but splitting them up again turned out to be a lot easier than I thought though, and I suck at electronics.
First off thanks for the link.It does help. I was OK until it mentions a special tool required to remove the rail hooks. I think I'll end up cutting it and adding an LED light.
what bracket did you go with? wondering b/c i am holding my plate on with a couple of zip ties on the passenger peg. Seeing how Fl decided to make an illegal plate mount a $1000 ticket, I figure I should place it correct.
I am going to do the reflector trick. Remove the reflectors from the undertail, take the reflectors off there bracket and use those brackets to hold the License. They have a tutorial here somewhere.
You don't have to cut it, but you have to take the entire rear fairing off to get to the plug....it's in the shop manual that is linked to this site...
I know it was a pain to do but I unplugged it and took it off without removing the rear fairing. I don't remember exactly how I did it though, but I know its possible.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.