Thread size and pitch???

[crawler]

Need the tsize and thread pitch for the mudflap hardware. I have my plate mount in the rear mudflap holes secured by two machine screws, one vanished last night.

Taking the other out to run to home depot isn't too viable because that would leave my mount hanging by two 20guage wires the light is attached with.

Thanks for the help guys.

 

[crawler]

Looks to be a m6x16. I'll buy a couple and find out for sure.

 

[BUBBA]

Looks to be a m6x16. I'll buy a couple and find out for sure.

Sorry, wish I could have helped but don't have access to the bike and tools right now.

Let us know if it is the M6 or not, will be good info the next time.
Thanks
Bubba

 

[crawler]

M6x16 is correct. These went in with a flat washer and a lock washer. Plenty of length and it has full thread engagement.

 

[cycleman]

Little locktite?

 

[crawler]

No, if I go to the track and run my (aftermaket) swingarm at full length then I need to be able to pull it easily. It should be fine with the lockwashers. It was good without them for 7000 miles before. I'll just put it on my list of things to inspect every oil change.

Good suggestion though cycleman, thank you.