Front sprocket

[dm_gsxr]

Ok, I'm going to replace the front sprocket. I have the service manual at hand and a good selection of tools. I've pulled the four bolts around the sprocket cover and the center speedo cable. While I have a little bit of wiggle, it's not coming off.

Suggestions? Did I forget a bolt?

2002 'busa.

Thanks.

Carl

 

[dm_gsxr]

It looks like the hydrolic clutch part on the left side needs to be removed. The picture shows that it's not there after the sprocket cover has been removed. Not having done this before, it might actually be a part of the cover and removing the two bolts would just take it out of the sprocket cover itself.

When I spoke to the service department when ordering the sprocket, they said it didn't need to be removed but since they're not standing here looking at it, they might not be thinking of the same thing I'm thinking of.

Anyway, thanks again.

Carl

 

[dm_gsxr]

Got it. Nevermind. Just needed to put some more motion to it. Man it's gunked up. Time to clean things up a little

Carl