yaas6996
Registered
Hi All,
Ive recently purchased a 2017 hayabusa on the insurance auction. Wasnt that badly damaged, mostly cosmetics.
Ive tried to start the bike but havent gotten any luck.
Im getting a C42 error. Ive done the following thus far:
- checked ignition switch in the on position and there's continuity.
- Checked continuity from the plug through the connector all the way to the ecu.
- I googled and searched everywhere for some form of guidance.
- I went through the whole wiring harness to check for broken wiring but nothing.
- My ignition switch is definitely okay.
- Checked side stand relay next to fuse box. thats fine
- Checked fuses, did this by doing continuity test with the multimeter
- Checked battery for sufficient power, thats ok
- Checked fuel pump, fuel pump primes when i add 12v and ground
- Checked side stand sensor, there is continuity there as well
- Checked clutch lever sensor, continuity there as well
- Ive got a spare key/master key and tried this key as well with no luck.
I literally turn the bike on with the keys. I press the run button and after 2 seconds it shows c42.
not sure what next to check or where to go from this point onward.
pictures as follows.
1 - picture of ignition switch
2 - picture of connector for the rf unit around the key
3 - traced wire images. Orange / w tracer and black-white tracer
4 - fuse box with relay
5 - Error message on the clocks.
Ive recently purchased a 2017 hayabusa on the insurance auction. Wasnt that badly damaged, mostly cosmetics.
Ive tried to start the bike but havent gotten any luck.
Im getting a C42 error. Ive done the following thus far:
- checked ignition switch in the on position and there's continuity.
- Checked continuity from the plug through the connector all the way to the ecu.
- I googled and searched everywhere for some form of guidance.
- I went through the whole wiring harness to check for broken wiring but nothing.
- My ignition switch is definitely okay.
- Checked side stand relay next to fuse box. thats fine
- Checked fuses, did this by doing continuity test with the multimeter
- Checked battery for sufficient power, thats ok
- Checked fuel pump, fuel pump primes when i add 12v and ground
- Checked side stand sensor, there is continuity there as well
- Checked clutch lever sensor, continuity there as well
- Ive got a spare key/master key and tried this key as well with no luck.
I literally turn the bike on with the keys. I press the run button and after 2 seconds it shows c42.
not sure what next to check or where to go from this point onward.
pictures as follows.
1 - picture of ignition switch
2 - picture of connector for the rf unit around the key
3 - traced wire images. Orange / w tracer and black-white tracer
4 - fuse box with relay
5 - Error message on the clocks.