I finished instaling the LC-1 Air Fuel Ratio Sensor Controller and wide band sensor in the Busa. I still have to wire up the SSI-4 interface so I can log the RPM and Throttle Position as well.
What you can see in the first picture:
1) Wide band O2 Sensor
2) Crouse Control Vacuum Solenoid
3) LC-1 Digital Air/Fuel Ratio (Lambda) Sensor Controller
4) SSI-4 Simple Sensor Interface 4 Channel
5) Speedo-Healer
6) Power Commander III USB
7) LC-1 calibration switch and status LED
8) Brake switch relay for cruise control w/LED brake lights
I'm glad the tail bulges out so far on the sides
I'm not fond of manufacturers putting enough wire on these things for a car and molding on connectors so you can't shorten up the wires. But at least I can get the extra out of sight.
The second pic is the PCIII and LogWorks windows.
What you can see in the first picture:
1) Wide band O2 Sensor
2) Crouse Control Vacuum Solenoid
3) LC-1 Digital Air/Fuel Ratio (Lambda) Sensor Controller
4) SSI-4 Simple Sensor Interface 4 Channel
5) Speedo-Healer
6) Power Commander III USB
7) LC-1 calibration switch and status LED
8) Brake switch relay for cruise control w/LED brake lights
I'm glad the tail bulges out so far on the sides
I'm not fond of manufacturers putting enough wire on these things for a car and molding on connectors so you can't shorten up the wires. But at least I can get the extra out of sight.The second pic is the PCIII and LogWorks windows.
