Whats best to clean and/or lube a chain

Matte_Black

Registered
Joined
Nov 21, 2011
Messages
291
Reaction score
0
Your thoughts on what works for you to clean your chain and what lube do you use.
Whats your methodology in the whole cleaning and lubing process, a friend of mine just asked and so I thought I'd ask the mighty Org


Thanks for your reply(s)

Matte_Black

Registered
Joined
Nov 21, 2011
Messages
291
Reaction score
0
Hey Charlie do you wash the kerosene off with water before putting on the lube?

SKECHE

Registered
Joined
Aug 16, 2010
Messages
2,552
Reaction score
25
i use a pickle and finish off with LPS to clean and then DuPont Teflon chain lube...:thumbsup:

cheferman65

Registered
Joined
Sep 12, 2007
Messages
3,730
Reaction score
26
Matte_Black said:
Hey Charlie do you wash the kerosene off with water before putting on the lube?

Can't vouch for the rest of the .org but I do. Little s100, hose, dry, warm, DuPont wipe off excess.

Sent from my iPhone using Forum Runner

dadofthree

Seasoned Beef
Donating Member
Joined
Sep 6, 2006
Messages
60,245
Reaction score
2,854
WD-40 , Maxim Chain Wax. When I'm out, going with the DuPont. 27K on original chain and sprockets. :thumbsup:

Gavilan

Registered
Joined
Apr 16, 2012
Messages
126
Reaction score
1
Wow, a pickle :oh:.... every day I learn something new ..

I use Berryman B-33 engine degreaser and WD-40 for cleaning,
and Motul chain lube factory line or Maxima chain wax, for lubricating.

It's works very well for me

Blanca BusaLess

Suffers from PBSD
Donating Member
Joined
Oct 7, 2009
Messages
23,678
Reaction score
4,991
Big canno Wd40 to blast it clean, wipe and let dry/evap for a bit and then go for short ride maybe five minutes. Come back and immediately put it on rear stand, while chain is still warm and spin and soak with the DuPont Teflon stuff from lowes, blue can. Gives me a chain even Sleepless Red would envy :laugh:



Ps......if you take the little red hose on the wd40 and bend it 90 degrees you can get both sides of chain from one side of bike.

kromdom

wannabe HOON
Donating Member
Joined
Feb 14, 2006
Messages
5,616
Reaction score
47
1. bike on rear stand, in Neutral
2. spin rear tire BY HAND to run chain through grunge brush
3. soak section of rag with kerosene
4. spin rear tire BY HAND to run chain thru rag
5. spin rear tire BY HAND and spray lube on chain
6. repeat every 500 miles. adjust slack as needed.

P.S. Good idea to also remove cover for front sprocket every now and then to clean the crud that gets caked/trapped there.


grunge-brush.jpg

thumbnail.aspx

mark3evo

Registered
Joined
Jul 10, 2010
Messages
2,051
Reaction score
3,077
Kersone ( Paraffin in England) with old Toothbrush, then Spray with 'Wurth' Performance dry chain lube (PTFE)

sigmapaul

Registered
Joined
Feb 25, 2009
Messages
18
Reaction score
0
What timing, I just got through cleaning my chain after 18 miles off road in the dirt. Here's what I do, takes all of 10 minuets:

1. Put bike on rear stand.
2. Start engine and put in 2nd gear.
3. While wheel is going around, spray on kerosene from a spray bottle and leave to soak for a few minuets.
4. Repeat #2 and use a grunge brush from Cyclegear (need to be very careful here) to clean chain then use a cotton towel to remove kerosene from chain
5. Done!

frisbee

GODSPEED RACING
Donating Member
Joined
Mar 19, 2002
Messages
15,645
Reaction score
106
kerosene won't break down the rings , i'm not sure what pickle juice will do. I know that when I was young and worked fastfood we used the pickle juice to scrub the grill with .

Hayabusawannabe

Registered
Joined
Sep 15, 2010
Messages
275
Reaction score
3
I was a little wary of kerosene at first (thought I might burn myself up) but I ended up using it. For lube I use this.
Back
Top