I'm going to install my stainless lines today , would anybody know if I have to remove any body work? I'm doing single lines up front, ss rear, ss clutch, and I have speed bleeders so this should make it much easier.
I know on a Gen 2 you'll have to remove the left side fairings to get to the clutch slave cylinder. I'd take them off anyway to make sure you don's spill any brake fluid on them and give you room to work.
I know on a Gen 2 you'll have to remove the left side fairings to get to the clutch slave cylinder. I'd take them off anyway to make sure you don's spill any brake fluid on them and give you room to work.
I know on a Gen 2 you'll have to remove the left side fairings to get to the clutch slave cylinder. I'd take them off anyway to make sure you don's spill any brake fluid on them and give you room to work.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.