ottafish
Registered
Hi All,
Been looking at doing a projector retrofit to my Gen2.. Have done other bikes in the past, but they've all been single units.
So, question ....
Has anybody swapped the high to low beam wiring? Here's what I'm thinking. I may try as I have a spare light assy..
I understand I may need to add some washers or packing to the setup to get the alignment
Unless someone has a 100% reason why it is a bad idea or will be a stupid thing to do, fair chance I'll do this this winter.
Thoughts?
Been looking at doing a projector retrofit to my Gen2.. Have done other bikes in the past, but they've all been single units.
So, question ....
Has anybody swapped the high to low beam wiring? Here's what I'm thinking. I may try as I have a spare light assy..
- Bi-Xenon projector, (with a good quality hid bulb) in the bottom position and wired as low beam, but with a high beam trigger for the solenoid shutter
- A dedicated High beam only projector in the top position - wired to high beam trigger. - top qualtiy LED for instant on / flash (and maybe with a white halo on low)
- By going this idea, it would put the high beam over the low beam - and make more sense as to a light throw pattern?
- The low beam shutter would open on high beam activation / flash
I understand I may need to add some washers or packing to the setup to get the alignment
Unless someone has a 100% reason why it is a bad idea or will be a stupid thing to do, fair chance I'll do this this winter.
Thoughts?