Gen 2 Tuned
- Thread starter Omega
- Start date
182 / 110 
Very nice. If the bike was white the figures would be 3% higher.
lankeeyankee
Banned
I believe 182 is stock for the white models. Hang On to her Champ! 
That is because the motor is trying to get away from those ugly plastics
Best post EVER....
piratediverjefff
Registered
piratediverjefff
Registered
Best post EVER....
Darren is a pretty funny guy
Looks good dude. Just think, the rate you and myself are at, you may have enough "hand me down" parts to have a drag bike in the next year
BiggDaddyBusa08
Registered
Just had my 08 stock motor on the dyno 2 weeks ago. It was tuned using ECU Editor and after a few tweeks it made 187 hp and 107 ftlb of torque. I have a TiForce full exhaust(4-2-1-2) on pump gas ( 87 octane). My dyno guy keeps telling me to get a sidewinder and use MR12.
cwalker2
Registered
My Gen II has a couple of minor mods besides the exhaust - still nothing internal. Was running a PCV for fueling and had only used ECU Editor to shut off limiters, run the air shifter, raise the rev limit etc. Later I tuned IAP map and zeroed out the PCV under 10% throttle. Results were good and drivability was quite possibly improved (very subjective). I recently took the whole PCV out and went with the ECU Editor for tuning the Alpha-N operation of the map. Like everyone before me, I too am pleased to say it responds very well to changes.
Last edited by a moderator:
You guys are getting some great results.
Johnnycheese
Registered
There is more your tuner left on the table but if you are happy good for you,
Similar threads
