why do you think so?
does the clutch "slide" ?
when yes
1st - messure the thickness of the entire clutch pack (for control) /
==> the abs. minimum is : 50.5 mm or 1.989"
2nd - messure the thickness of each driven plates (not the steels) and look the min. th in the manual
you better do all measurement in [mm] but not in [inch] - inch is depending at your mess. tool possibly a little bit inaccurate compared to mm
example :
1.980" = 50.29 mm / 1.985" = 50.42 mm / 1.988" = 50.49 mm / 1.989" = 50.52 mm
even the min th of all driven plates alone is better than manual says AND the clutch slides instead of this
do 1st the small (& cheap) repair
by replacing only one thin driven (3.0mm) and one thin (2.3mm) steel by the thicker ones
a. 21451-24F 00 - 3,8 mm
b. 21441-24F 10 - 3,8 mm
then try again.
does the clutch "stutter" ?
look for "black marks" at the steels - if they have, change all the steels.
the entire clutch is in principle changeable between ´99-´01 and ´02-´07
for exact little differences compare my two microfiches
´99-´01
and
´02-´03 (-´07)