hey guys.. my clutch went out. I replaced it...had a hard time bleeding it... got it bled, started her up and its almost slamming into gear. I havent driven her yet, but when i put her in first..it doesn't sound good. It does the normal click sound but then also has a slam. I installed an outlaw clutch. I put the friction plates in properly. The steel plates were a pain in the ass... i did put the dull side towards the motor on all of them. I know that steel plates 5 and 6 are thicker on the stock one and im not sure if i put the two thicker plates in the right spot because I couldn't even tell if they were thicker on this new clutch. They all looked almost the same. I thought maybe two were bigger but honestly just think it was me trying to think they were because I was so frustrated. Could this be causing the issue im having if the 2 steel plates werent in spots 5 and 6 from the inside counting out? I can clearly tell on the stock steel plates that they are thicker. Please let me know!