endlessperformance
Registered
I restored everything back to stock after I tried installing the XTRE Box and the bike still has no power. Here is my observations:
-Battery has 12.2 V
-One Post of starter relay has 12.2V
-Gauge cluster, headlight, and fuel pump don't come on when key is turned to on (Kill switch is in Run mode, bike in neutral, and kickstand up), Nothing comes on as it normally would
-Many of the pins on the ignition harness and cluster have 12.2V when the bike is keyed on yet the cluster doesn't light up
-Not even the clock is on; I was able to get it to go on for short bursts by touching some of the ignition harness pins with a test light, but it would go off. Touching these pins also caused the gauge cluster needles to jump up and the backlights to come on.
-No fuses are visually blown
I don't have a diagram to verify which pins are which on the harnesses for the ignition and gauge cluster so if anyone has the 2008 Wiring Diagram please post it or email it to me.
I am so confused at this point and have no idea.
Any ideas? How can I test the ECU? How do I test the relays? The only thing I did from the time it ran to when it started acting up was install the XTRE mod and I cut the correct wire for it(green/black wire); I have since removed that and restored everything 100% back to stock.
PLEASE HELP GUYS!
-Battery has 12.2 V
-One Post of starter relay has 12.2V
-Gauge cluster, headlight, and fuel pump don't come on when key is turned to on (Kill switch is in Run mode, bike in neutral, and kickstand up), Nothing comes on as it normally would
-Many of the pins on the ignition harness and cluster have 12.2V when the bike is keyed on yet the cluster doesn't light up
-Not even the clock is on; I was able to get it to go on for short bursts by touching some of the ignition harness pins with a test light, but it would go off. Touching these pins also caused the gauge cluster needles to jump up and the backlights to come on.
-No fuses are visually blown
I don't have a diagram to verify which pins are which on the harnesses for the ignition and gauge cluster so if anyone has the 2008 Wiring Diagram please post it or email it to me.
I am so confused at this point and have no idea.
Any ideas? How can I test the ECU? How do I test the relays? The only thing I did from the time it ran to when it started acting up was install the XTRE mod and I cut the correct wire for it(green/black wire); I have since removed that and restored everything 100% back to stock.
PLEASE HELP GUYS!