As some of you know, GsxrBots pass the Underbelly Wing to me to see if I had better fit on my bike, but I didn't have such luck. I try it two ways to see what fited best...
First try, I attached the front screw of the wing with the body and then try to fit the two clips on the back, but the hole didn't match each other, the left side hole was off by 1" and the right side hole was off by 1/2".
Second try, I attached the two back clips first and then try to fit the front screw, but the hole of the wing was about 1/2" to the front and about 1 1/2" out (away from the body)
Ok, so theres some custom bending need it on this wing I started playing around with the bends that are already on the wing to make it a lil shorter, I bend them lil by lil, I had to take the wing in and out couple of times. After about 1 hour and 15 min later, I finaly got the wing on, its not perfect, it still doing some pressure, but that was enough for me.
The wing lost the original shape due to the extra bending, it look uneven with the rest of the body, the back section of the wing(where the two holes are) looks lower on the back but higher on the front, the front part of the same back section is almost hitting the pipes underneath the bike(about less than1/4"). On the other hand there is a lot of clearance on the midpipe. Here are some pics, the first two I stole from Steve
First try, I attached the front screw of the wing with the body and then try to fit the two clips on the back, but the hole didn't match each other, the left side hole was off by 1" and the right side hole was off by 1/2".
Second try, I attached the two back clips first and then try to fit the front screw, but the hole of the wing was about 1/2" to the front and about 1 1/2" out (away from the body)
Ok, so theres some custom bending need it on this wing I started playing around with the bends that are already on the wing to make it a lil shorter, I bend them lil by lil, I had to take the wing in and out couple of times. After about 1 hour and 15 min later, I finaly got the wing on, its not perfect, it still doing some pressure, but that was enough for me.
The wing lost the original shape due to the extra bending, it look uneven with the rest of the body, the back section of the wing(where the two holes are) looks lower on the back but higher on the front, the front part of the same back section is almost hitting the pipes underneath the bike(about less than1/4"). On the other hand there is a lot of clearance on the midpipe. Here are some pics, the first two I stole from Steve