voodoodoo
Registered
So i'm doing the valve check and the darn valve cover plug is stuck. Heated the engine before i tried to remove it but No luck. Bumped the starter to put the cams in the correct position and found out that ex nr4 has one valve off. 0.17mm. And intake nr 1 is at 0.008 wich is snug but ok.
All the others are ok but as i have to shim both the cams need to come out and according to the manual you have to "reverse" the crank 180 degrees when refitting the camchain and tensioner to tighten the slack in the camchain ..
Possible to put it in 6th gear and turn the rear wheel?
All the others are ok but as i have to shim both the cams need to come out and according to the manual you have to "reverse" the crank 180 degrees when refitting the camchain and tensioner to tighten the slack in the camchain ..
Possible to put it in 6th gear and turn the rear wheel?