I did it on my 06, with no problems or modifications necessary, just rotate the fastener on the shift shaft 180 degrees. I'm not sure there is clearance on the 08. I would need to look or see a picture...
I did it on my 06, with no problems or modifications necessary, just rotate the fastener on the shift shaft 180 degrees. I'm not sure there is clearance on the 08. I would need to look or see a picture...
I did it on my 06, with no problems or modifications necessary, just rotate the fastener on the shift shaft 180 degrees. I'm not sure there is clearance on the 08. I would need to look or see a picture...
Yes, it wasn't an issue on 1st Gen's, but there is clearance issues on the Gen 2's. Looks like you would have to cut the shifter rod to length and re-thread it to get the clearance. I would like to have a spare on hand before starting, just in case. Me and Murphy are real good friends! Just wondering if someone had seen something that I missed.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.