Im getting ready to head out into the Garage to adjust the Pre-load on the new 1000 lb Spring I just had installed, Its a little stiff and the Bike sits 1" higher than it did before the install.
I want to lower it back down and maybe loosen it up a little, I was told to adjust the rings, Locking ring up then Adjusting ring down until I reached where I wanted it. Then of course locking ring back down.
Is there a special tool to adjust the rings or do you guys have your own thingamajiggers to do it.
And does this sound like its going to work for me.
I want to lower it back down and maybe loosen it up a little, I was told to adjust the rings, Locking ring up then Adjusting ring down until I reached where I wanted it. Then of course locking ring back down.
Is there a special tool to adjust the rings or do you guys have your own thingamajiggers to do it.
And does this sound like its going to work for me.