gsxr1216
Registered
I just bought a 2002 hayabusa with a mcxpress stage 2 setup with secondary injectors, intercooled, and a silver mcexpress controller fuel box (gen 1 box i beleive) to run the secondary injectors, the kit is from around 2005.
The previous owner didnt know how to change the programming in the box so I'm trying to figure out how to be able to access and change the programming for when i dyno the bike to verify the tune. Does anyone have any info you can share with me as to how to change the progrmming in that box and what software and cabling is needed to access this box. i didnt see anywhere to plug anything into it unless the plugs are buried somwhere i have not found yet? from some of my research it appears this may be a DOS controlled box, but again i dont know what i need in the way of cables or software in order to make changes to it
Attached is a pic of the box with the cover off of it,
Any help or insight would be greatly appreciated!
The previous owner didnt know how to change the programming in the box so I'm trying to figure out how to be able to access and change the programming for when i dyno the bike to verify the tune. Does anyone have any info you can share with me as to how to change the progrmming in that box and what software and cabling is needed to access this box. i didnt see anywhere to plug anything into it unless the plugs are buried somwhere i have not found yet? from some of my research it appears this may be a DOS controlled box, but again i dont know what i need in the way of cables or software in order to make changes to it
Attached is a pic of the box with the cover off of it,
Any help or insight would be greatly appreciated!