Newbie question ;)

[JOHNNYWHISPERS]

hey guys , im setting up my dry nitrous system . so far have my bottle mount done , spray bar is mounted in airbox , i am going to run ecu editor as soon as i order the window switch . i see you can use the solenoid that normally would open the flapper valve in the airbox . the airbox mode was already done so im not sure where the solenoid for that is or should be . and do i need to use the with a relay inline between that and the nitrous solenoid ??

thanks john

 

[twotonevert]

Sorry bro, I dont know, but there will be lots of answers soon. Welcome to the oRg if I have not said it before.

 

[coreywiley]

to the org

 

[JOHNNYWHISPERS]

thanks for the warm welcome guys ! always good to have a source for guys with the same kind of speed addictions

 

[smithabusa]

for $50 I make a very nice plug and play harness that eliminates you doing any wiring, and will automatically switch maps when the nitrous solenoid comes on,
ECU Nitrous Harness

if you plan to do it yourself put a relay on it or you will cook the ecu's flapper circuit the first time you turn the solenoid on. the solenoid is mounted on a bracket on left side inner frame rail under tank right next to barometric pressure sensor

 

[LeDauz]

will that work with a wet system from nitrous express?

 

[smithabusa]

Yes u could just leave fuel alone and pull timing when nos is active
Posted via Mobile Device

 

[JOHNNYWHISPERS]

so i assume that the toggle puts power to the nitrous solenoid and switches the map over ?? how do i order this from you

 

[smithabusa]

Yep ECU Nitrous Harness
Posted via Mobile Device