Need some help

[SAMBUSA]

I was recently doing some work on the Busa and had the rear tail section off. Long story short, like a dumb a$$ I put the hump on without reattaching the locking mechanism. So, how do I get the hump off now?

 

[BA BUSA]

Do you have a aftermarket undertail

if so just pop out the push pins and reach
up in there and release the latch.

 

[SAMBUSA]

Do you have a aftermarket undertail

if so just pop out the push pins and reach
up in there and release the latch.

Got an aftermarket undertail, but the black plastic is still in there between undertail and locking mech. Its where all my electronics sit

 

[nitrousjunkie]

You have to snake your hand up the left side of the subframe and pull the cable,I used a pair of needle nose pliars.::

 

[nitrousjunkie]

Or you can get it from the rear,again snake your hand up to the actual latch and slide it open.

 

[Aquaman]

So what you are saying is that you removed the little green clip that holds the lock?
If you remove the undertail,you should be able to reach up at the key lock and open it with the key.

HtH's

 

[SAMBUSA]

So what you are saying is that you removed the little green clip that holds the lock?
If you remove the undertail,you should be able to reach up at the key lock and open it with the key.

HtH's

No, I disconnected the cable.

 

[Aquaman]

Ok,see where my thumb is?if you can get to it,push this pc. to the left and it will open.

 

[nitrousjunkie]

Ok,see where my thumb is?if you can get to it,push this pc. to the left and it will open.

+ 1.it can be done,I've done this stupid act twice! LOL!

 

[Aquaman]

+ 1.it can be done,I've done this stupid act twice! LOL! [/QUOTE]
It pushes real easy too
Put some 'hair' around it,you'll find it....

<!--EDIT|brendanp
Reason for Edit: None given...|1144001491 -->