i have lsl sliders and had to replace right side plastics. i need the measurements from lsl to get the center hole. it worked perfect the first time and id like to do it again except i lost the instructions.
1 mark the position on the fairing(dimensions shown in picture)
(1) upper fairing bolt; (2) bore; (3) axle, swingarm.
2 drill a small pilot hole (2) check the alignment to the mounting point. Then enlarge the hole until the fairing doesn't jam or scrub the spacer.
from 1 to 2 is 52 mm, from 3 to 2 is 495mm
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.