SS4Luck
Registered
I’m finishing the install on my evil arm tomorrow and have 3 questions:
1) are any of the axle blocks reused from the stock setup to the evil arm? Or do you just slide the axle through and torque the nut down?
2) do the adjuster blocks just slide into the end of the arm tubes and get held in place by chain tension/axle bolt torque?
3) what’s the torque spec on the pivot bolt nut
1) are any of the axle blocks reused from the stock setup to the evil arm? Or do you just slide the axle through and torque the nut down?
2) do the adjuster blocks just slide into the end of the arm tubes and get held in place by chain tension/axle bolt torque?
3) what’s the torque spec on the pivot bolt nut