What year bike?
On a 2001 with a Brocks Alien head, PC III USB, Air box mod, intake cam mod and Pair valve set up for crankcase pressure relief we hit 182hp.
Is this average, below, or above?
Is this average, below, or above?
will a new dyno need to be done or will the shop be able to print this out?
I hate the idea of paying $1100 for a pipe, $100 for a filter, $300-500 for a tune ---- then get my bike dyno'ed and find out that it may or maynot be accurate..
As long as I see the improvement from the baseline run, then all is good. I don't really care if my bike has more power than anyone else's, just if it's been improved by my mods and tuned properly with smooth power delivery.
I agree with you on that.................... I just think it would be nice if all dynos read close to the same. I feel like you shouldnt have wonder when it comes to a piece of equipment that was designed to measure something..
I agree with you on that.................... I just think it would be nice if all dynos read close to the same. I feel like you shouldnt have wonder when it comes to a piece of equipment that was designed to measure something..
Did you watch them dyno it? Reason I say that is because a few people have had issues with Beach Blvd about being charged for something and they not doing the work. That might be a generic busa sheet they give everyone. They might have loaded in a PC map and called it good. .Hard to say with those crooks.
Your sheet doesn't have any info at the bottom if it did then all they would have to do is pull up that folder click on the run and click SAE instead of STD before they print it out. If they tell you they can't do that then they are full of it.. Every good tuner uses SAE. You only see STD when they want the #'s to be higher. I have spent many many hours on a dynojet 248 tuning cars.