Dyno Results 2003 Busa

arthur39

Registered
Joined
Jun 22, 2009
Messages
249
Reaction score
6
I had this tuned over the weekend. Thanks to Tom Miceli, the dyno was a Factory-Pro EC997 eddy-current low-inertia dynamometer with SAE corrections. Mods being Fully Muzzy Titanium, air box mod with BMC Filter 16/41 gearing. I had the ECU flashed by Mr. Smith with unified ignition and fuel maps with all short stacks (ECU editor by Petrik). I synched the throttle bodies before tune with smoothed it out a bit as well. I took a gamble with all short stacks and it paid off. The power commander became handy here for final tuning because we were able to build an advanced map and apply fuel to each cylinder seperately. The picture shows how much Tom was able to gain with the tune. First run was 161 and 102 torque, Final was 177.63 and 106.61 ft/lbs. I tote the bike all over and the power band is smoothe from idle on up. Guess I'll keep the busa :laugh:

scan0003.jpg

Commuta_Busa

Donating Member
Joined
Mar 21, 2003
Messages
7,569
Reaction score
40
Tommy is a great guy and has a wealth of knowledge. :beerchug::thumbsup:

Back-again-Busa

Registered
Joined
Sep 1, 2009
Messages
2
Reaction score
0
Arthur mind telling where ya had it dynoed and what the goin charge there is ?
I used to race with Tommy

By the way great #'s:thumbsup:

arthur39

Registered
Joined
Jun 22, 2009
Messages
249
Reaction score
6
sure no problem, he is at Xtreme Machines located in Millstone New Jersey, the cost was $300

Back-again-Busa

Registered
Joined
Sep 1, 2009
Messages
2
Reaction score
0
Cool ,i didnt know he was working there < been out of the seen to long!
Thanks for the info

KvHotDog4

Registered
Joined
Feb 17, 2009
Messages
1,300
Reaction score
11
I had the ECU flashed by Mr. Smith with unified ignition and fuel maps with all short stacks (ECU editor by Petrik).

What is this......sounds like something thats needed. Mine is a 2007 when I had it dynoed it was only 149hp. Mods TRE, air filter and down 1 up 3. Since then I also have the full muzzy and power commander but I took the gear back to factory for gas milage I have not had a chance to dyno it with new stuff.

luccaRSA

Registered
Joined
Sep 10, 2008
Messages
118
Reaction score
1
Here is mine. Just wanna compare it, but first I have to convert yours to metric:laugh:. This was done month ago at 1800m above sea.
Stock engine, no PC, redesigned exhaust, no GIPro.
In your opinion, are those good results or average.

dyno.jpg

JimmyTNT

Registered
Joined
Dec 27, 2009
Messages
45
Reaction score
2
****, i would be happy with 160whp for those mods! congrats! Maybe the 03's are special! (crosses fingers) haha
Back
Top