Freechance
Registered
I thought this was going to be a hard install but it was really easy as for the ddm kit it was plug and play...
The wiring was a direct plug in...
And the bulbs and housing was the same..
Just like installing new bulbs in the bike ..
I used the right side air tube to put all the ballasts since i dont need it...
I also installed a wolsten tech relay its a TDR-P ....
On the relay there 4 prongs
1= goes to head light plug (+) on bike
2= not used
12+ = hot (+) goes to battery
L= goes to red wire from ballast (+)
G= gnd ground
Only thing i need to figure out it on the low beam plug which wire is hot im not sure if its the white or the black/white..
The wiring was a direct plug in...
And the bulbs and housing was the same..
Just like installing new bulbs in the bike ..
I used the right side air tube to put all the ballasts since i dont need it...
I also installed a wolsten tech relay its a TDR-P ....
On the relay there 4 prongs
1= goes to head light plug (+) on bike
2= not used
12+ = hot (+) goes to battery
L= goes to red wire from ballast (+)
G= gnd ground
Only thing i need to figure out it on the low beam plug which wire is hot im not sure if its the white or the black/white..