Wanting to put rear fender, mud flap, plate holder back on. What size are those bolts? I bought the bike used so it's gone. All i see up there are holes where it mounts. I guess there's a welded nut in there? Thanks Randy
They were plastic fasteners. You should be able to get some from a body shop. They were the rivet type that you push the pin in the center in to take them out.
**edit. If you pull you seat off I believe there are a couple on the piece that connects your tail together. You may be able to see them when you only pull the hump off but I don't remember.
No nuts, holes are threaded. Head size is or was 10mm but any bolt with correct thread pitch will work no matter head size. Ride over to Home Depot and try one or two.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.