Bolt size rear mud flap/fender gen II

groran1000

Registered
Wanting to put rear fender, mud flap, plate holder back on. What size are those bolts? I bought the bike used so it's gone. All i see up there are holes where it mounts. I guess there's a welded nut in there? Thanks Randy
 
They were plastic fasteners. You should be able to get some from a body shop. They were the rivet type that you push the pin in the center in to take them out.

**edit. If you pull you seat off I believe there are a couple on the piece that connects your tail together. You may be able to see them when you only pull the hump off but I don't remember.

That's of you wanna bring one in to match.
 
If I remember right mine had 4 10mm bolts holding it on. Its been a while so I may be off base.
 
If there's a weld nut unvolved you'll have to get the specific part / bolt . Otherwise a small bolt and nut or a small push pin should work.

The free on-line manual should list the factory component and specs.
 
No nuts, holes are threaded. Head size is or was 10mm but any bolt with correct thread pitch will work no matter head size. Ride over to Home Depot and try one or two.
 
Back
Top