o yes nice theme
if u take a 20 Nm torque wrench 5 imes to the same nut/screw you will get 100 Nm´s onto
View attachment 1607670
query :
is the manufaktory called "stahlwille" known in usa?
this is the very best you can get 4 money,
becaus the very special thing about it is that you do not have to put it back to zero to save the torque feather inside.
the "stahlwille" you can leave in the box / drawer for "years" at any torque
and it will work still fine, means the calibration is almost never lost - proper use preceded
tolerance of torque is at 1%
this one (see pic) 4 - 20 Nm ~ 3 -14 ft lb + 1/4" ratchet i use with hex tool 8 only for the 6mm screws
e.g. at clutch cover or chain cover
View attachment 1607671
using that "rolls royce" of the tools i never ever can tear out a inner thread in the aluminium.
my little hint - see this link :