I noticed some new gen II owners have had minor problems setting up the shift light. If you follow this it will work the first time. And later on down the road when you disconnect the battery you will have to set it again. I keep these instructions handy for that reason.
The 08 owners manual can be a little vague when setting up the shift light the first time.
I hope this will clarify the process.
LEFT BUTTON - SELECT ***** RIGHT BUTTON - ADJUST
1. Press and hold the left (SELECT) button.
2. Turn the ignition on, continue to hold the select button down until the instrument panel boots up .
3. Release the select button.
4. Press the right (ADJUST) button one time.
5. A symbol that resembles a lightning bolt will appear.
6. Pressing the right button again will toggle through the shift light settings --- on, flash or off.
7. Press the left (SELECT) button again... one time.
8. Little dots/squares appear - this is the brightness setting for lamp.
9. Press the right button to add more dots - more dots brighter lamp.
10. Press the left (SELECT) button again- tach needle will move to default setting.
11. Press the right (ADJUST) button to move the tach needle to the desired setting.
( 500rpm increments below 8000 rpm, 250 above 8000 rpm)
12. Press the left (select) button to exit out. Ride safe - Busa159
The 08 owners manual can be a little vague when setting up the shift light the first time.
I hope this will clarify the process.
LEFT BUTTON - SELECT ***** RIGHT BUTTON - ADJUST
1. Press and hold the left (SELECT) button.
2. Turn the ignition on, continue to hold the select button down until the instrument panel boots up .
3. Release the select button.
4. Press the right (ADJUST) button one time.
5. A symbol that resembles a lightning bolt will appear.
6. Pressing the right button again will toggle through the shift light settings --- on, flash or off.
7. Press the left (SELECT) button again... one time.
8. Little dots/squares appear - this is the brightness setting for lamp.
9. Press the right button to add more dots - more dots brighter lamp.
10. Press the left (SELECT) button again- tach needle will move to default setting.
11. Press the right (ADJUST) button to move the tach needle to the desired setting.
( 500rpm increments below 8000 rpm, 250 above 8000 rpm)
12. Press the left (select) button to exit out. Ride safe - Busa159