remove the front seat
remove the rear seat
remove the rear grab bar
notice the plastic rivets....you will need to be gentle here, push in the center of each one with the end of an allen wrench. they go in about 1/8 inch then with your fingernail lift up on the outer flange.
there are 6 in the underside of the tail and two just under the back seat holding a bridge across the plastic.
use your fingernail to remove the small black plastic caps on the bungee posts to reveal an allen head.
remove the front two bungee posts.
there are two phillips head screws inside of two rubber boots under the back seat , one on either side. remove the screws.
of course remove the fairing screws on either side
remove the two phillips head screws that hold the rear seat locking mechanism.
use both hands to spread the tail apart at the bridge.
voila