Rear foot pegs...


flynjay

Registered
#1
After I installed my HMF high mounts a year ago, I couldn't put my rear pegs on because of a clearance issue under the body plastic. Anyway, that's about ready to be fixed and I want to put my pegs back on. But I want something other than stock. Does anyone know of any other rear pegs that will fit.

Thanks!!
 
#3
(heavybusa @ Oct. 05 2006,18:03) Protek is what I have.

Try the board sponsors. (I'm sure they will post soon)
Protec here too. There a little wider than stock, and have better "grip". They look a whole lot better too.
 

CAT3

Donating Member
Registered
#6
Got front and rear ProTek's as well, Charles from S&T hooked that up. Both are comfy, light and look good. GL.
 

flynjay

Registered
#7
The ProTeks look good...

Guess I wasn't clear on what I wanted. I'm looking for the whole assembly, not just the pegs themselves.
 
#8
I too am curious what other kind of passenager pegs are out there. My girlfriend is looking for something that is a little more comfortable for her. She says the vibrations get to her feet a little bit after 45 or so miles.
 

Don Hardcastle

Busa Ridin' Sailor (ret)
Donating Member
Registered
#10
(flynjay @ Oct. 05 2006,18:02) After I installed my HMF high mounts a year ago, I couldn't put my rear pegs on because of a clearance issue under the body plastic. Anyway, that's about ready to be fixed and I want to put my pegs back on. But I want something other than stock. Does anyone know of any other rear pegs that will fit.

Thanks!!
I am not sure what clearance issues you have. I installed my HMF Dual High Mount system last month and the tail section fit with the rear peg brackets. I did have to push the plastic in just a bit to put the screws in but nothing that anyone would notice without a close inspection.

Don
 

chrisjp

GM of Haya's in the Hills
Donating Member
Registered
#11
i was able to mount my rear cowl with no issues and 4 washers extra thick for the spaceing...my undertail and cowl all lined up no issues
 
#13
(usn04limited @ Oct. 06 2006,17:06)
(flynjay @ Oct. 05 2006,18:02) After I installed my HMF high mounts a year ago, I couldn't put my rear pegs on because of a clearance issue under the body plastic.  Anyway, that's about ready to be fixed and I want to put my pegs back on.  But I want something other than stock.  Does anyone know of any other rear pegs that will fit.

Thanks!!
I am not sure what clearance issues you have.  I installed my HMF Dual High Mount system last month and the tail section fit with the rear peg brackets.  I did have to push the plastic in just a bit to put the screws in but nothing that anyone would notice without a close inspection.

Don
The mounting brackets I got from HMF with my set were bent with too much of an offset, which caused a clearance issue for the rear tire. Basically if I took hard hard bump with alot of suspension travel, the brackets would have cut into both edges of my rear tire. The brackets are getting replaced this coming week.

See this thread...


I'm looking for a "different" style of brackets. I want a clean look that doesn't have the mounting brackets for the stock exhaust. It looks like I'm going to have to go with a one off design from a local machine shop. We will see.
 

Most likes - Past 7 days

Forum statistics

Threads
170,747
Messages
3,070,331
Members
46,844
Latest member
sarpe
Top