Post Your 1/4 Times And Mods.

[Brett Rahn]

guys
I raced Saturday at Cecil county raceway and air was at Corrected altitude 805 and Barometer was 29.32 so not killer but good air and I went 8.400 and 8.42 see time slips, how many 300 lb guys on a 500 lb bike can do this on Motor no power adder, stock injectors stock air box ecu tune, I am happy bike #159

[RedBull]

Always runs the best right before they break . . .

[piratediverjefff]

That's a $12,000+ Carpenter motor with a billet crank,titanium rods,etc.,be pretty hard to break.

[sjg34]

08 1441, head, cams, hand slider, and 7 over. So far 9.07 @ 152. Bike and rider 764 lbs. One of us need to go on a diet and I am guessing it will be me

[Brett Rahn]

just had it freshened in spring by Bob, and was spotless after 200 plus runs, good oil and keeping it changed helps, Amsoil Dominator 10w30 baby,

[Dennis]

500 pound stock motor, pump gas, hand clutch, street exhaust 08 @ 63-1/2". I'm in the right lane, a gen1 ZX14 is in the left lane. DA was about 1700. I know the light was bad, but I was just trying to figure the bike out with the new gear and wasn't concentrating on that.

[Kevin Jones]

I wish I lived as close to the track as you Dennis. Doesn't mean I could even get near as good as you but I sure wish I could.

[sjg34]

I have a modified motor and I can't get close to Dennis on his. I am jealous

[Dennis]

Thanks guys. Practice helps a lot, and a lot of practice helps even more. Tomorrow is the last day this year for my track and weather looks ok so I'm hoping to get into the 8.80's. Sometimes trying too hard is my undoing though.

[sjg34]

Our last points race is tomorrow also. I made some changes to the clutch hoping to finally get my 8.999

[Brett Rahn]

Dennis what do you weigh, and how did you get bike to 500lbs, as mine with BST and TI winder is 512

[Dennis]

I weigh 160 out of the shower, so probably 175 suited. A basic Busa at 63" with an exhaust weighs around 515-520. I removed rear brakes completely, lithium battery, and aluminum subframe. I could easily remove one front rotor and caliper, and the oil cooler. That would probably be another 10 pounds. I don't imagine a Ti-winder is much lighter than my exhaust.

My other stock motor bike weighs 460 and went 8.53@ 158 last year on MR12. The 60' was better but the weight is a big factor.

[sjg34]

How much et and mph do you gain from mr12

[Dennis]

This is on a good (not great) air day. On a bad air day I get about .13 and 2 mph. My theory is that the bike is not tuned for it and is lean on a good air day so I don't gain as much mph.

[Busa_Rob]

8.50 @170ish.Stck hand clutch,14# no controller. daily driven street bike. RCC Stage 1 turbo.Built,tuned and ridden by me.62"WBView attachment 397007

Your the guy i need to talk to

[gsxrdan2]

Your the guy i need to talk to

Sure fire away

[Busa_Rob]

Sure fire away

609-401-8675 call me tomorrow anytime...if i dnt pick up please leave a message because im going to the track and I barely have service...i really need some info on your setup because im going the same route

[gsxrdan2]

609-401-8675 call me tomorrow anytime...if i dnt pick up please leave a message because im going to the track and I barely have service...i really need some info on your setup because im going the same route

Sorry just seen this..how did it go???

[Busa_Rob]

Sorry just seen this..how did it go???

It was a good day at the track....whats your number??

[Joshua Hinojosa]

9.42@ 148.93 mph I have air shifter, shinko hookup tire, stretched, brocks rear lowering link, 40 shot nitrous, +6 teeth rear sprocket, -1 tooth front sprocket, brocks full race exhaust, clutch mod, tune from Schnitz racing for N/A and nitrous. Need to improve my launch. Bike has done 8.9's with a good rider.