Oil Pan Removal

[TexBusa]

Does anyone know how to get the oil pan off of an '04 GSX1300R Haybusa? I need to swap it out. I know that plastics have to come off, but it looks like the pipes are in the way. Any help would be appreciated.

 

[badassbusa]

you have to remove plastics, then remove your exhaust system. remove all the bolts holding the oil pan, i think they are 14 bolts. remove the pan, remove the gasket. do not use razer blade or scraper to remove the old gasket from the block side, use a hand wire brush. make sure you your regulator don't fall from the block. install your gasket on the alignment pins, install your oil pan & torque the bolts to 10 N-M or 7 LB-Ft. the last one is inch pound, not foot pound.
one more advice, don't thight all four corners first.
good luck

 

[Johnnycheese]

install your oil pan & torque the bolts to 10 N-M or 7 LB-Ft. the last one is inch pound, not foot pound.
one more advice, don't thight all four corners first.
good luck

you forgot to replace that little rubber gasket under the bolt that goes under the right rear corner and yes it is 84 INCH LBS. I would edit that because 7 inch lbs is wrong