O2 bung\02 info

[maddogs_1340]

Gretz,All
Who here at the board can guide me into the right directions for a stainless steel o2 bung for a stock sensor? My stock bung was about .160- .170 thick.
Well gonna try and run the stock o2 with my orient pipe and custom map lol.
Well Brock racing says i should leave it out and keep it by passed.
Any guru's here tell me at what rpm does the o2 fall off or does it stays active all the time?

Please advise,maddog

 

[dadofthree]

My '08 hasn't had an O2 sensor since I left the dealer with it new. Running Brock's Street Meg Short.

Good luck with it.....

 

[Dozerdriver]

I am not sure what rpm or throttle position the 02 sensor stops reading at. I do know I have run with the o2 and without the o2 on a full system mapped bike. The throttle response is better without the o2 working (bypassed). The fuel mileage might be better with it hooked up but haven't confirmed this yet. I prefer the snappier throttle over gas mileage... I average 38 stop and go and 45 highway without the o2. Hope this helps..

 

[maddogs_1340]

gretz,Dozerdriver
Well have been told i should run it been told nah leave it out.
Sounds more like it's gonna be left out lol.
Thanks to all.
But still need the knowledge on where to get one tho,anyone?
And maybe someone can confirm where it quits at?
Thankx,maddog