5. Remove dash assembly bolts, 2 (11)
6. Pull dash completely out of upper rubber grommets firmly far enough to reach wiring harness on left rear.
7. Slide rubber boot back from harness enough to depress harness connector retaining clip
8. Remove dash assembly
12. Install HID kit per instructions running wiring behind dash to the right side air intake tube
Hid ballast can mount nicely in its bracket on top of the right hand air intake tube with sheet metal screws if you choose. Seal tops of screws with permatex sealer.
Come to think of it, on step 11 the low beam is held in place with a retaining clip... The bulb should pull out after removing the retaining clip. It's the high beam that twists in.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.