OB_OkcBusa
Registered
I have purchased a Micron Carbon round 4-2-1 exhaust system as well as a Power Commander.
The installation was time consuming, but relatively easy. I have been plagued with a leak on #3 up at the port hole. I didn't change the original gaskets (Haven't found anybody with new ones). Has any body else had similair problems...Any fixes other than new gaskets. Micron suggest turning the gaskets over and "cleaning them up w/ 600 grit sand paper. Has anybody tried this? Any other suggestions would be greatly appreciated...I am having Busa Withdrawals!
The installation was time consuming, but relatively easy. I have been plagued with a leak on #3 up at the port hole. I didn't change the original gaskets (Haven't found anybody with new ones). Has any body else had similair problems...Any fixes other than new gaskets. Micron suggest turning the gaskets over and "cleaning them up w/ 600 grit sand paper. Has anybody tried this? Any other suggestions would be greatly appreciated...I am having Busa Withdrawals!