ham4864
Registered
I brought my first used 2006 Busa it has a aftermarket single sided D&D exhaust system.
The pair valve has also been removed and it has the 4 block off plates installed.
So one day I decided to prop up the gas tank and start inspecting things. I noticed a long rubber hose hanging and blocked off. I said to myself this looks out of place. So after looking at the manual come to find out it was the hose from the vacuum control solenoid valve that goes to the intake air control valve actuator, so I reconnected it.
Day two I decided to remove and inspect the air box after opening the air box I noticed the small box mod was done(I think)because it was not there.
So the big question is, Can and should I remove the hose that I reconnected and cap it off, and also remove the intake air control valve actuator and seal up the hole?
So after all of that what would I have done is that the small air box . i will look for a airbox that as not been modified.
The pair valve has also been removed and it has the 4 block off plates installed.
So one day I decided to prop up the gas tank and start inspecting things. I noticed a long rubber hose hanging and blocked off. I said to myself this looks out of place. So after looking at the manual come to find out it was the hose from the vacuum control solenoid valve that goes to the intake air control valve actuator, so I reconnected it.
Day two I decided to remove and inspect the air box after opening the air box I noticed the small box mod was done(I think)because it was not there.
So the big question is, Can and should I remove the hose that I reconnected and cap it off, and also remove the intake air control valve actuator and seal up the hole?
So after all of that what would I have done is that the small air box . i will look for a airbox that as not been modified.