Intake & Exhaust Camshaft Position

[Youkai]

I was going to confirm with my local busa mechanic but wanted to verify here cause the org is the best community. I am about to rebuild my motor with a new head gasket, freshly flat-surfaced block/cylinder head, and APE studs/nuts. My question is the camshaft position. I don't believe the manual instructions are correct because on my motor the two outside pistons are UP and the two middle pistons are DOWN. My mechanic still has my cams but I believe I only saw one arrow per cam. I believe the intake arrow was pointed towards the inside of the motor gasket and the exhaust arrow was pointed straight up. Does anyone know if thats right? Thanks.

 

[cdhoroho]

there is alignment lines on the end of the cam that are to be level with the top of the head they also both point each other
there is also to be 15 pins from mark to mark from the exhaust cam tot he intake cam