I know that but are the part numbers stamped on the bars? Trying to figure out how to tell which bar is which on a set of used bars.
Handlebar replacement - easy or not?
- Thread starter wreckwriter
- Start date
DougE
Registered
That I do not know. I'd be able to take a look this evening. I have a stock set of bars i just took off the bike.
That's the fun part...
I believe they have a slight rearward angle on them...take them and hold them in place and you will see which is which by doing that.
You can see the slight angle in the attached picture...that and the hole for the switch gear...
Mine should be here around noon. I'll figure it out. Looking at the two helibars I don't see any appreciable difference
It's only for the holes/dimples that locate the switch housings by their plastic pins.
Hold the bars up to the switches and you'll see which is which.
Hold the bars up to the switches and you'll see which is which.
OK thanks. I'll figure it out when they get here.
Forgot the easiest way of all, factory grip glue on left bar. Goes stop to stop now, no contact.
Similar threads
