dyno question??

[busaguy1981]

Would it make any sense dyno a stock busa(nothng but a k&N)? If so, how much does it usually cost to dyno a bike?

[route69471]

I would guess you would be looking at somewhere around $65 for a shop to put your bike on a dyno and make 2-3 pulls and give you the print out. I think its a good idea to dyno it stock, and use that as a baseline for when you start adding mods. just make sure to return to the same shop for your next dyno runs so your numbers dont get screwed up, for HP & TQ numbers will vary from dyno to dyno.

[busaguy1981]

Thanks man, would love to have new pipes and pcIII, but moneys always tight. Just want the bike to runs it's best no matter if anythings added or not.

[rubber2burn]

A good reason to have your Stock Busa Dyno'ed is to get the Numbers it is putting down before you add an exhaust and motor work done. That way you have a baseline. Normally it depends on the tuner as to what they will charge for Hp Torque Pulls I have seen them run anywere from $10-100 bucks

[Micfitz]

My stock 06 with bmc filter and 16/42 made 150.1 with a fuel air of 12.1 straight line across the rpms.

Yes good to dyno, but a let down in stock form. Neat to actually state hard numbers when talking to friends though.