cost of replacing Steering head bearings ?

[CopMagnet5oh]

how much are the bearings and how much labour is it to replace Steering head bearings on 1st gen busa ?

thank you.

- Kons

[mike1180]

All balls makes a tapered set.
They are way better than the OEM

All Balls Racing

[turbobusa2000]

All balls makes a tapered set.
They are way better than the OEM

All Balls Racing

I just replaced mine this year with those. They seem to be well made. Install wasn't to bad either. Goodluck

[rusheriv]

OEM at Motorsports Super Center (board sponsor) $23.15 ea. Pt#09267-30010
Labor is going to vary, probably count on $50/hr X 1 to 2 hrs.

[schleife]

Moin moin,

how much labour? About 3 to 4 hours if you've done it before.

But IMO it's a must to be an experienced mechanic, don't try that stuff just with the knowledge of a screwdriver...

Ciao
D1

[rusheriv]

I guess I was a little conservative on the labor time. I usually do all my wrenching after snorting a couple of lines, that combined with the knowledge of a screwdriver.