The easy way is to go in from the bottom. Push out the 6 plastic pins on the cover over the front fender and reach up and change it. I however, prefer to take off the windshield by removing the two allen screws, then pull on the windshield and the two rubber expansion nut things will slip out with the windshield. Take off the inner plastics around the gauges and remove the two mounting bolts, 10mm, that hold the gauges in and pull on the gauges while you wiggle the gauges and it will come out of the two rubber grommets holding the gauges. Now you have access to the bulb. The bulb is held in with a spring. To release push in and down . You can now change the bulb and you have access to the height adjustment for the low beam as the light is set low from the factory on most busas. I put a silverstar in the high beam too, but to tell you the truth I think the stock bulb works better in the high beam for some reason.
