T-Rex Swingarm Spool Install (Pic)

[goblinsix]

I had to add spacers to clear the swingarm....the rearstand was going to make contact with the arm and rip it up. How does it look? Ehhhh?

 

[NINJA KILLER]

Lookin' Good!

 

[GPW]

Nice image

 

[Ranger]

Nice They dont look used yet..

 

[goblinsix]

Na...they aren't used yet, but I did have to take them on and off three times and they did cause the chrome on the swingarm around the bolt are to peel. I was not happy at all.

I put it up on the stand tomorrow for some basic work. I was posting the pic mainly to see if I put too many spacers in there. I had to goto Home Depot and buy really long 8mm bolts and 5 washers for each side. I'm hoping they don't snap under any type of pressure.

 

[BIG GUY]

I would use the grade 8 bolts. They are the strongest that the home improvements stores sell. The first time you put it up on the rear stands I would probably have someone else there with you to catch it if any thing goes wrong.

 

[305 axe]

Drill & tap to a 10 mm bolt. {made me feel better} Most of the weight is up front any way.

 

[DEMMYM]

Looks like you extended them what 1/4"

Should be ok, But keep an eye on it for bending

 

[goblinsix]

I will...I'm not dazzled by these spools. Actually it's not the spools...it's the relative mounting position on the swing-arm.

 

[Blanca BusaLess]

Looks nice.
Super nice looking wheel...

 

[micbusathens]

Should be ok, But keep an eye on it for bending

+1.....because of the extension.I believe its gonna be ok though

 

[BY1Wheel]

+1