steering dampener

[proud dad]

I'm gonna do this

[rocktober]

well i got the dampener of put 80/ 90 gear oil in , took me an hour to get the middle bolt startrd in the hole , but the stud on the post won't tightn up , just keeps spinning, i know when i took it off that it was tight as hell, whats up with that, that stud post had a retangle hole, is there any way i could have lost a part , cause it looks like there needs to be someting to hold tha post in the grove.............i'am no mech. thats for sure

[raydog]

Rockober, two things......1) mine was hard to break free as well, when replacing nut: finger pushing down from top when tightening, good dose of lock tite, and push in codder key installed on shaft are the things I did when replacing. 2) HAVE YOU BEEN READING YOUR STRAND ABOUT THE IMPORTANCE OF SPELLING DAMPER? lol

Raydog

[raydog]

Hey Cookie, my spirits will not be dampened with the installation of the dam damping damper, it's getting damp outside.

[rocktober]

look at the pic.'s posted and , i finialy got on after a number of Mo FO's, thanks all

[Cookie]

(raydog @ Jul. 12 2007,13:12) Hey Cookie, my spirits will not be dampened with the installation of the dam damping damper, it's getting damp outside.

Damp it, Ray, ,, you're killing me here!

Don't get your drawers all wet in a wad over this! You could be thrown under the bus and called a teacher of all names!

[raydog]

Cookie, just get down here and ride with us...didn't you say you were looking at relocation? (I'm not going to say, "isn't it too damp up there?"). Seriously, for your business or something? (sorry for thread jack)

And Roctober.....what pictures? Raydog

[rocktober]

sorry,.....could not do any pic.'s, took it for a ride and it feels tighter now

[rockadaous]

(rocktober @ Jul. 12 2007,20:32) sorry,.....could not do any pic.'s, took it for a ride and it feels tighter now

sounds like you got it right

[Powers739]

Dampener ... Dampener ... Dampener